Kaliburn Plasma Electrode 277282 For Spirit 150A Plasma Cutting Consumables

Kaliburn Plasma Electrode 277282 For Spirit 150A Plasma Cutting Machine accesssories

We can offer you all plasma consumables for , Kjellberg, Esab, Koike, Komatsu, Thermadyne, Kaliburn such as: electrode, nozzle, shield, swirl ring, inner cap, retaining cap, water tube, torch body and so on.

FAQ:

Q1:Can I get a free samples to check the quality?

A:Sure,we can supply the free samples but you need bear the express cost by yourself.

Q2:Will I afford the carrier charge?

A:Yes,you will afford the express charge or your account is OK.

Q3:Can I add my trademark on my products?

A:Yes,we need your certificate of authorization.

1. HEC Brand

We make metal cutting system and plasma cutter as well as torch and consumables. We make plasma cutting machine and fiber laser cutting machine with high quality and reliablity.

2. Cut Performance

HEC plasma consumables use high quality material and standard process to make sure the highest quality. Our consumables cutting performance is as the same as orginial OEM manufactory.

3. Good Price

HEC plasma consumables are good quality with low price make customers best requirement and saving money.

4. Big Catagory

HEC sell all kinds of plasma consumables include , EASB, Kjellberg, Koike and also supply some torch.

Technical Support:

1. avoid the expansion of plasma arc

If the plasma arc is only extended and expanded in order to reach the working surface (the plasma arc starts at the beginning and end of the cutting), this will cause the non normal damage of the nozzle. If you use the right edge of the starting point, select the right "broken arc" signal time, this problem can be avoided.

2. to reduce unnecessary arcing time

When the arc discharge nozzle and electrode consumption are very fast, so the arc should be placed on the cutting torch cutting the workpiece within walking distance. Try not to have an empty arc. The cutting machine should begin to execute the program immediately after receiving the signal from the start arc, and should not be suspended.

3, keep the plasma gas dry and clean

Plasma system need to dry and clean gas plasma in order to work properly, dirty gas is usually compressed gas system, it will relationship exertion of life, resulting in non normal damage. Method for testing the quality of gas cutting torch in the test state, put a mirror in the below, torch gas consumption, if there is a gas and mist on the mirror, you need to identify the cause and correct.

4. Method for prolonging the service life of the plasma wearing parts

ensure the correct air pressure and flow rate of the plasma gas

The correct pressure and flow rate of the plasma gas are very important to the service life of the wearing parts. If the pressure is too high, the life of the electrode will be greatly reduced;

If the pressure is too low, the nozzle's life will be affected.